Vanagon Syncro AWD F4-2109cc 2.1L (MV) (1989)
-
Drive in new oil seal to stop
-
Install lock ring
-
Install drive flange with VW 391
-
Install wave washer
-
Press circlip into groove with VW 454 and at same time check that washer is centered
-
Replace cap
-
Install wheel bearing housing with axle shaft
-
Install bolts for radius rod, wheel bearing housing and lower control arm.
^
Tighten to: 100 Nm (73 ft lb)
CAUTION: Do not damage axle shaft boot.
-
Install tie rod, brake caliper and upper ball joint
^
Tighten to: Brake caliper to housing 240 Nm (177 ft lb)
Ball joint to upper control arm 60 Nm (44 ft lb)
-
Install brake hose bracket
-
Bolt axle shaft flange with spacer washer to drive flange
^
Tighten to: Axle shaft to drive flange 35 Nm (26 ft lb)
Wheel bolts 180 Nm (132 ft lb)