780 V6-2849cc 2.8L SOHC B280F (1987)
Inspection 4-Door Models
INSPECTION OF CONTACT STRIP ON 4-DOOR MODELS (200, 700/900)
The following action should be taken if the antenna cannot be extended completely after cleaning, or if the antenna rod does not retract completely into
the antenna tube:
- Check if antenna motor is equipped with a contact strip as illustrated. If so, strip should be cut so that ends are separated by a gap of at least 3 mm.
- If strip is not cut, it should be cut at two points to provide a gap of at least 3 mm as illustrated. Do not slacken retaining screws.
Checking control module on 4-door models (200)
If antenna operation is still faulty following above action, control module should finally be checked.
- Disconnect control module connector by depressing spring catch and pulling connector downward.
- Check operation of antenna with new control module, p/n 3533347-5.