Volvo Workshop Manuals
940 L4-2.3L SOHC VIN 88 B230F (1992)
Powertrain Management > Tune-up and Engine Performance Checks > Idle Speed > System Information > Adjustments > Identification of Bendix/Bosch Systems > Page 4984
Fig. 359 ADJUST THROTTLE PULLEY AND CABLE
Check for smooth operation of the control pulley and cable.
Adjust the throttle cable so it is stretched at idle, but does not affect the control pulley position. At idle the control pulley should touch the stop.
With the accelerator pedal fully depressed, the control pulley should touch the full throttle stop.
Fig. 362 ADJUST AUTOMATIC TRANSMISSION KICKDOWN CABLE
Check the kick-down cable (if equipped) adjustment by pressing the accelerator pedal to the floor and measuring the distance between the cable
Fig. 360 CONNECT AND ADJUST LINK ROD
Connect the link rod.
Place a 1 mm (0.04 in) feeler gauge between the control pulley and idle speed stop. Clearance between the lower adjustment screw and the end
|[PREV PAGE] [NEXT PAGE]|