Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Rear Sensor > Page 1471

Page 3
background image

AM9. Install hub

Ensure that spindle is clean.

Note:  Do not pack hub with grease. Component is already lubricated with correct quantity of special grease. 

Use sleeve 9995294 to press in bearing inner race. 

Note:  Locating sleeve used to remove hub will now be pressed out by spindle.

AM10. Fit and tighten new nut

Tighten nut until axial clearance is taken up exactly. Continue to tighten to 100 Nm (74 ft. lb.). Finally, angle-tighten nut to 45°. 
Use angle gauge 9512050.

AM11. Install new dust cap 

Use sleeve 9995225 and plastic mallet.

AM12. Mount brake disc in accordance with marking 

Ensure that all mating faces are clean. Install wheel locating stud. Tighten pin to 8 Nm (6 ft. lbs.).

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Rear Sensor > Page 1471

[PREV PAGE] [NEXT PAGE]