V50 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Fuel Pressure Sensor: Service and Repair
Pressure sensor, fuel rail (FRP)
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Draining the fuel system
Remove:
-
the screws for the upper timing cover
-
the upper timing cover.
Drain the fuel system. See: Fuel system pressure release See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and Repair/Fuel
System Pressure Release.
Removal
Removing the fuel pressure sensor
Caution! Place paper on top of the generator.
Disconnect the connector for the sensor.
Remove:
-
the screw for the fuel pressure sensor
-
the sensor.
Installation
Note! For tightening torque, see: Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening
Torque
Installing the fuel pressure sensor