Volvo Workshop Manuals
V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Front Wheel Sensor [KKKK] > Page 644
Wheel Speed Sensor: Service and Repair
Replacing front wheel sensor wiring
The wiring to the front wheel sensor is integrated into the engine compartment wiring. In the past, damage to the wheel sensor wiring has meant
Note: The earlier repair kit, P/N 9442120-3, should no longer be used
Replacing wheel sensor cable harness
Raise the car and remove the wheel on the side on which the wiring is to be replaced.
Disconnect cable harness from:
Brackets on spring strut and in wheel arch.
Clip on brake pipe
Clip in engine compartment
The new cable harness should be routed in the same way as the old to avoid damage caused by rubbing.
Cut off the old cable harness approximately 20 cm from the cable duct and discard.
|[PREV PAGE] [NEXT PAGE]|