Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Maintenance > Fuses and Circuit Breakers > Fuse Block > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 2443

Page 12
background image

Remove all relays and shunts bridged to the control module. Note the locations.

Release the catch on the rear. Use a screwdriver.
Lift and pull out the control module.

Check

Check that the control module's connectors are intact.

Installing the control module

-

Press the control module into place so that the catch on the rear engages

-

Position the connector. Carefully press the connector down.

Note! The pins are fragile. Check that the connector goes straight down into the control module.

-

Tighten the screw for the connector

-

Check that the connector cover is correctly positioned. Remedy if necessary

-

Install the relays and shunts. Note their locations

-

Install the integrated relay / fusebox. See Installing the integrated relay / fusebox in the cargo compartment.

Ordering software

Order the software. See 9494723.

Integrated Relay/Fusebox, Engine Compartment, Replacing

Integrated relay / fusebox in engine compartment

Exposing

-

Disconnect the battery lead. See Battery, replacing See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery,
Replacing 

-

Disconnect the air cleaner (ACL) housing.

Maintenance > Fuses and Circuit Breakers > Fuse Block > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 2443

[PREV PAGE] [NEXT PAGE]