volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Resetting the Service Reminder Indicator (SRI)|Page 3149 > < Resetting the Service Reminder Indicator (SRI)
Page 1
background image

Maintenance Required Lamp/Indicator: Service and Repair
Description of the Ignition Modes (Ignition Switch Positions)

Ignition modes [Vehicles equipped with Remote Key]

Various ignition modes are accessed by inserting the remote key into the ignition slot. The remote key can be removed from the ignition slot by pressing
the key in. It will then be ejected slightly and can be removed from the slot. The gear selector must be in position P (Park)

Note:

The brake pedal must not be depressed when accessing ignition modes I or II

Ignition mode 0

Insert the remote key in the ignition slot.

Ignition mode I

Press the remote key into the ignition slot and press START/STOP ENGINE.

Ignition mode II

Press the remote key into the ignition slot and press START/STOP ENGINE for approx. 2 seconds.

Ignition mode III (engine start)

Start the engine 
1. Fasten the seat belt.

WARNING:

Before starting the engine, check that the seat, steering wheel and mirrors are adjusted properly. Make sure the brake pedal can be
depressed completely. Adjust the seat if necessary.

2. Insert the remote key into the ignition slot. Press the key until it is drawn into the slot ‹›.

NOTE:

The remote key should be inserted into the ignition slot with the key blade end of the remote pointing out and the key pad facing up.

3. Depress the brake pedal ‡.

WARNING:

An extra mat on the driver's floor can cause the accelerator and/or brake pedal to catch. Check that the movement of these pedals is
not impeded. Not more than one protective floor covering may be used at one time.

4. Press and release the START/STOP ENGINE button. The autostart function will operate the starter motor until the engine starts.

The starter motor operates for a maximum of 10 seconds. If the engine has not started, repeat the procedure.

‹› On vehicles with the optional keyless drive, it is only necessary to have a remote control in the passenger's compartment.
‡ If the vehicle is moving, it is only necessary to press the START/STOP ENGINE button to start the vehicle.

WARNING

Always remove the remote key from the ignition slot when leaving the vehicle, especially if there are children in the vehicle.
Never remove the remote key from the ignition slot while driving or when the vehicle is being towed. The steering lock could
otherwise be activated, making it impossible to steer the vehicle. Never remove the remote key with keyless drive function (option)
from the vehicle while driving or during towing.
Always place the gear selector in Park and apply the parking brake before leaving the vehicle. Never leave the vehicle unattended
with the engine running.
Always open garage doors fully before starting the engine inside a garage to ensure adequate ventilation. The exhaust gases contain
carbon monoxide, which is invisible and odorless but very poisonous.

Resetting the Service Reminder Indicator (SRI)|Page 3149 > < Resetting the Service Reminder Indicator (SRI)