XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Fuel Pressure Sensor: Service and Repair
Fuel pressure sensor, replacement
Removal and Installation
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Drain the fuel injection system. See Fuel system pressure release See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and
Repair/Fuel System Pressure Release.
Remove the charge air pipe over the engine. Seal the openings.
Remove the cover over the fuel rail.
Removing the fuel pressure sensor
Caution! Collect any spill using paper or similar.
the tie strap for the cable for the sensor
the screw for the sensor
Installing the fuel pressure sensor
Note! For tightening torques, see Specifications See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening
the screw for the sensor. Tighten.
the tie strap for the wiring. Connect the cable to the sensor
the cover over the fuel rail.