Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel Drive Shaft, Replacing > Page 2941

Page 4
background image

Remove:

-

the 2 screws (1)

-

the inlet hose

-

the hose clamp (2)

-

the connector (3)

-

the tie strap for the cable.

Remove the turbocharger (TC) control valve from the air cleaner (ACL) housing

Remove:

-

the plastic nut on the wheel arch side

-

the air cleaner (ACL) housing.

Replacing sensor cable, left-hand side

Insert a hand under the fuse box. Disconnect the cable from the clips on the brake cable.
Pull up the sensor until the connector for the new cable is up.
Remove the tape and connect the connector.
Install the cable in the clips on the brake cable.

Caution! The yellow markings on the cables must be in the clip.

Raise the car.

Installation

Note! For tightening torques, see Specifications See: Brakes and Traction Control/Specifications/Tightening Torque.

Installing the sensor and the cable

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel Drive Shaft, Replacing > Page 2941

[PREV PAGE] [NEXT PAGE]