RDX L4-2.3L Turbo (2008)
5. Inflate the tire to 300 kPa (3.1 kgf/cm2, 44 psi) to seat the tire bead to the rim, then adjust the tire pressure to 220 kPa (2.2 kgf/cm2, 32 psi).
NOTE: Make sure the tire bead is seated on both sides of the rim uniformly.
6. Check the valve stem nut tightening torque, then install the valve stem cap.
7. Check and adjust the wheel balance, then install the wheels on the vehicle. Torque the wheels nuts to specifications.
8. Remove the jack stands, and lower the vehicle.
9. Connect the HDS, and memorize the pressure sensor ID(s).
