RDX AWD L4-2.3L Turbo (2010)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair.
3. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
4. Remove the spring clip (A) and the control pin (B), then separate the shift cable end (C) from the selector control lever (D).
5. Remove the nuts securing the shift cable bracket (E).
6. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair.
7. Disconnect the transmission range switch connector.
8. Pry the lock tab of the lock washer (A) on the selector control lever (B), and remove the locknut (C), the lock washer, the spring washer (D), and
the selector control lever.