RDX AWD L4-2.3L Turbo (2010)
10. Disconnect the tie-rod ball joint from the knuckle using the ball joint thread protector and the ball joint remover See: Steering and
Suspension/Suspension/Ball Joint/Service and Repair/Ball Joint Removal.
11. Remove the lock pin (A) from the lower ball joint (B) then remove the castle nut (C).
NOTE: During installation, install a new lock pin after tightening the new castle nut.
12. Disconnect the lower ball joint from the knuckle using the ball joint thread protector and the ball joint remover See: Steering and
Suspension/Suspension/Ball Joint/Service and Repair/Ball Joint Removal.