RL V6-3.5L (2007)
14. Install the pulley (with pump driveshaft) in the pump housing.
15. Coat the new 16.8 mm O-ring (A) with power steering fluid, and position it in the bottom of the pump housing.
16. Coat the new 47.2 mm O-ring (A) with power steering fluid, and position it in the bottom of the pump housing.
17. Set the plate (B) with its "H" mark (C) facing up, and align the slot (D) in the pump housing.
18. Set the pump cam ring (A) with its "MS" mark (B) facing down, and align the slot (C) in the pump housing.