TL FWD V6-3.5L (2009)
NOTE: All connector views are wire side of female terminals.
9. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
-
If the terminals look OK, go to step 10.
10. Reconnect the connectors to the passenger's under-dash fuse/relay box, turn the ignition switch to ON (II), or press the engine start/stop button to
select the ON mode, and do these input tests at the following connectors.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 11.
11. If multiple failures are found on more than one control unit, replace the driver's under-dash fuse/relay box (includes the driver's MICU). See:
Maintenance/Fuses and Circuit Breakers/Relay Box/Service and Repair/Driver's Under-Dash Fuse/Relay Box (MICU) Removal/Installation If
input failures are related to a particular control unit, replace the control unit.