TL FWD V6-3.5L (2009)
Seat Occupant Sensor: Service and Repair
Front Passenger's Weight Sensor Replacement
Removal
NOTE:
-
Removal of the front passenger's weight sensors must be done according to Precautions and Procedures. See: Air Bag Systems/Air Bag(s) Arming
and Disarming/Service and Repair
-
The front passenger's weight sensors are part of the seat frame and must be replaced as an front passenger's seat frame assembly.
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the front passenger's seat frame/front passenger's weight sensor as an assembly. See: Body and Frame/Seats/Service and Repair/Front
Seat Frame Replacement
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
The front passenger's weight sensor are part of the seat frame and must be replaced as an assembly.
1. Install the removed parts to the new seat frame/front passenger's weight sensor as an assembly.
2. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
3. Clear any DTCs. See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview
4. Calibrate the ODS unit. See: Air Bag Systems/Testing and Inspection/Programming and Relearning/ODS Unit Initialization
5. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator
should come on for about 6 seconds and then go off.