100S Quattro Wagon (Canada) V6-2.8L (AAH) (1992)
/v6-2.8l_(aah)/Page-2378001.png)
Cellular Phone: Technical Service Bulletins
Transceiver, Installing
TRANSCEIVER, INSTALLING
^
fold back left side of trunk carpet
^
remove four left carpet liner securing caps
^
starting in top rear corner, pull back and remove left side trunk liner
^
remove telephone harness ground wires from ground point (arrow) located in left rear of trunk
^
cut off eyelet connector and strip insulation from ends of ground wires
^
measure and cut a brown 16 gauge (1.0 sq.mm) jumper wire approximately 30 in. (76 cm) long
^
strip insulation from ends of jumper wire
^
solder one end of jumper wire to existing harness ground wires
^
insulate solder connection with electrical tape or heat shrink tubing
^
properly crimp eyelet connector (locally available) to other end of jumper wire
^
fasten jumper wire to ground point
^
using transceiver bracket as a template, mark three mounting holes (arrows) on left inner trunk wall so that bottom two mounting holes line up with
center of bolt 1 and bottom of oval hole 2
CAUTION
A reinforcement panel is welded behind the trunk wall in this area. DO NOT drill on or in line with the spot welds.
^
using a 1/8 in. drill bit, drill holes at marks
^
insert mounting screw into each hole
