100S Quattro Wagon (Canada) V6-2.8L (AAH) (1992)
Cellular Phone: Technical Service Bulletins
Handset Cradle and Speaker, Installing
HANDSET CRADLE AND SPEAKER, INSTALLING
^
remove handset cradle screws (Torx T15) and separate cradle halves
^
cut off wires from inside of cradle
^
using template included with installation kit, mark and drill a 5 mm hole (arrow) in center of lower handset cradle
^
remove felt lining from center console tray
^
insert plastic nuts into three front square holes (arrows) in bottom of tray
CAUTION
Use care when removing/installing speaker grill. Tabs on the rear of the grill can be broken off if the grill is forced or removed/installed improperly.
^
remove speaker grill screws 1 and carefully remove speaker grill
^
remove screws from telephone handset connector (arrow) and remove connector from grill
^
install speaker over pins in grill and install retaining clips over pins
^
connect speaker wires
^
reinstall telephone handset connector and tighten screws