90S Quattro (Canada) V6-2.8L (AAH) (1993)
Steering Gear: Service and Repair
Without Servotronic
Power steering gear, servicing
CAUTION: Keep work area and components clean. Do not attempt to weld or straighten steering components.
Notes: The power steering uses hydraulic oil, Part No. G 002 000. Components marked with an asterisk (*) are included in the repair kit and
should always be replaced when servicing the system. Moisten all seals with hydraulic oil before installing.
1. Steering gear housing/steering gear
Removing and installing refer to
Adjust toe after removing and installing
2. Seal*
Always replace
Removing see Fig. 1 and Fig. 2
3. Circlip
Can only be removed and installed with steering rack removed
4. Retaining ring
Slide on steering rack to stop
Install in groove
5. Boot
Can be replaced with steering gear installed
Adjust toe after replacing
6. Clamp
Use screw-type clamps for repair
Threads face toward bulkhead
7. O-ring*
Always replace
8. Adjusting screw