90S Quattro (Canada) V6-2.8L (AAH) (1993)
/v6-2.8l_(aah)/Page-1456001.png)
Suspension Strut / Shock Absorber: Service and Repair
Removal and Installation
1. Raise and support vehicle, then remove wheels.
2. Disconnect sway bar from strut assembly.
3. Disconnect tie rod end from strut using a suitable tie rod end puller.
4. Remove bolts holding lower end of strut to hub.
5. Remove nuts holding upper strut mounting nut cap, then remove cap.
6. While supporting strut assembly remove upper strut mounting nut, then remove strut from vehicle.
7. Do not allow brake fluid line or electrical cables to become stressed or damaged.
8. Reverse procedure to install, tighten fasteners to specifications.
