audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - clutch unit > < Removing and installing clutch release bearing with release lever and guide sleeve

A1

Renewing input shaft oil seal
Renewing input shaft oil seal
Special tools and workshop equipment required
   
t  Extractor tool -T20143/1-
  W00-2958
t  Thrust piece -T40008-
t  Sealing grease -G 052 128 A1-
  W00-1002
Procedure
l  Gearbox removed
–  Remove release bearing → Chapter.
–  Pry out oil seal using extractor tool -T20143/1-.
  Note
Take care not to damage contact surface for oil seal on input shaft.
–  Clean contact surface and sealing surface.
  A34-0614
–  Pack space between sealing lip and dust lip -arrow- half full with sealing grease -G 052 128 A1-.
  N32-10016
–  Drive in new oil seal onto stop (take care to keep oil seal straight).
–  Install release bearing → Chapter.
  A30-0018

Exploded view - clutch unit > < Removing and installing clutch release bearing with release lever and guide sleeve