A1
Exploded view - hydraulics (RHD) |
1 - | Clutch slave cylinder with release bearing |
q | Can only be renewed after removing gearbox |
q | Removing and installing → Chapter |
2 - | Bleeder connection |
3 - | Retaining clip |
q | To remove and install pipe, pull out retaining clip as far as it will go |
4 - | Bleeder screw |
q | 4.5 Nm |
q | Bleeding clutch system → Chapter |
5 - | Dust cap |
6 - | Retaining clip |
q | To remove and install pipe, pull out retaining clip as far as it will go |
7 - | Seal |
q | Different versions according to type of connection; for correct version refer to → Electronic parts catalogue |
q | Renew if damaged |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
8 - | Brake fluid reservoir |
9 - | Seal |
q | Must be fitted in supply hose |
10 - | Supply hose |
11 - | Seal |
q | Must be fitted in supply hose |
12 - | Clutch master cylinder |
q | Removing and installing → Chapter „Removing and installing mounting bracket with clutch master cylinder“ |
13 - | Retaining clip |
q | To remove and install pipe, pull out retaining clip as far as it will go |
14 - | Seal |
q | Different versions according to type of connection; for correct version refer to → Electronic parts catalogue |
q | Renew if damaged |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
15 - | Pipe |
16 - | Bracket |
q | Attached to body |
17 - | Retaining clip |
q | To remove and install pipe, pull out retaining clip as far as it will go |
18 - | Seal |
q | Different versions according to type of connection; for correct version refer to → Electronic parts catalogue |
q | Renew if damaged |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
19 - | Bracket |
q | Attached to body |
20 - | Pipe |