A1
| Removing and installing gearbox housing and selector unit - exploded view |
| 1 - | Countersunk bolt → Item |
| 2 - | Flange shaft with spring |
| q | Removing and installing → Chapter |
| q | Assembling → Chapter |
| 3 - | Circlip |
| q | For sealing cap → Item |
| q | Fitted in gearboxes manufactured from 21 01 8 onwards |
| 4 - | Sealing cap |
| q | Secured by circlip in gearboxes manufactured from 21 01 8 onwards |
| q | Removing and installing (without circlip) → Chapter |
| q | Removing and installing (with circlip) → Chapter |
| q | Select correct components from → Electronic parts catalogue. |
| 5 - | Circlip |
| q | For grooved ball bearing on input shaft → Item |
| 6 - | Reversing light switch -F4- |
| q | 20 Nm |
| q | With captive seal (fitted shortly after gearbox was first introduced) |
| 7 - | Seal |
| q | Not fitted on all gearboxes |
| 8 - | Oil drain plug |
| q | Tightening torque → Fig. |
| 9 - | Seal |
| q | Always renew |
| 10 - | Locking bolt |
| q | 45 Nm |
| q | For selector shaft |
| 11 - | Bolt |
| q | 15 Nm + 90° |
| q | Replacement part always supplied as bolt with captive washer |
| q | Always renew; for correct version refer to → Electronic parts catalogue |
| q | Correct allocation of replacement bolts → Fig. |
| 12 - | Bolt |
| q | 15 Nm + 90° |
| q | Without washer |
| q | Always renew; for correct version refer to → Electronic parts catalogue |
| q | Correct allocation of replacement bolts → Fig. |
| 13 - | Selector unit |
| q | Servicing → Chapter |
| q | Removing with gearbox in vehicle → Chapter |
| 14 - | Bolt |
| q | 20 Nm |
| q | Always renew |
| 15 - | O-ring |
| q | Always renew |
| 16 - | Clutch housing |
| q | Servicing → Chapter |
| 17 - | Gearbox housing |
| q | Servicing → Chapter |
|
|
