Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Enginecrankshaft group, pistons >
< Assembly mountings - exploded view
A1
Power unit
4-cylinder direct petrol injection engine (1.4 ltr. 4-valve turbo), mechanics
Engine assy,cylinder block,crankcase
Assembly mountings
Removing and installing engine mountings
Removing and installing engine mountings
Removing and installing engine mountings
Special tools and workshop equipment required
t
Support bracket -10 - 222 A-
t
Adapters -10 - 222 A /19-
t
Engine support bracket (basic set) -T40091-
Removing
–
Disengage coolant hose
-1-
at engine cover panel.
–
Unscrew bolts
-arrows-
and remove engine cover panel.
–
Remove bolts
-arrows-
.
–
Detach electrical connector
-1-
for coolant shortage indicator switch -F66- and move coolant expansion tank to side.
–
Set up support bracket -10 - 222 A- on top edges of body flanges (left and right) and longitudinal member (right-side), as shown in illustration.
–
Attach hook of spindle -10 - 222 A /11- to engine lifting eye.
–
Apply light tension to spindle.
–
Remove nut
-1-
and move earth wire clear.
–
Remove bolts
-arrows-
for support arm of engine mounting.
WARNING
Risk of accident.
Do not loosen nut
-1-
unless renewing engine mounting.
–
Remove bolts
-arrows-
and detach engine mounting.
Installing
Installation is carried out in the reverse order; note the following:
l
Tightening torques
→ Chapter „Assembly mountings - exploded view“
Note
Renew the bolts tightened with specified tightening angle.
–
Fit engine mounting on longitudinal member.
l
The positioning holes
-arrows-
must align. If necessary, check with suitable drill bit.
–
Initially screw in bolts
-arrows-
by hand until they make contact.
–
Tighten bolts.
Note
Disregard
-item 1-
.
–
Initially hand-tighten bolts
-arrows-
for support arm of engine mounting as far as stop.
l
The support arm must not turn when you tighten the bolts.
–
Tighten bolts.
Note
Disregard
-item 1-
.
–
Install engine cover panel
→ Fig.
.
Power unit
4-cylinder direct petrol injection engine (1.4 ltr. 4-valve turbo), mechanics
Engine assy,cylinder block,crankcase
Assembly mountings
Removing and installing engine mountings
Enginecrankshaft group, pistons >
< Assembly mountings - exploded view