A1
| Poly V-belt drive - exploded view |
| 1 - | Poly V-belt |
| q | Check for wear |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen |
| q | Removing and installing → Chapter |
| q | Do not kink |
| q | When installing, make sure it is properly seated on pulleys |
| 2 - | Bolt |
| q | With washer |
| q | Renew |
| q | Lubricate thread with oil before fitting |
| q | Contact surface must be free of oil or grease |
| q | 150 Nm + 180° further |
| 3 - | Poly V-belt pulley |
| q | For crankshaft |
Caution
|
| q | Removing and installing → Chapter |
| q | Contact surfaces must be free of oil or grease |
| 4 - | Bearing bush |
| q | Contact surfaces must be free of oil or grease |
| 5 - | O-ring |
| q | Renew |
| 6 - | Idler roller |
| q | For poly V-belt |
| q | 40 Nm |
| 7 - | Bolt |
| q | Tightening torque → Item |
| 8 - | Poly V-belt pulley |
| q | For coolant pump |
| q | Removing and installing → Chapter |
| 9 - | Bolt |
| q | Tightening torque → Item |
| 10 - | Coolant pump |
| q | Removing and installing → Chapter |
| 11 - | Bolt |
| q | Tightening torque → Rep. gr.27 |
| 12 - | Alternator |
| q | Removing and installing → Rep. gr.27 |
| 13 - | Bolt |
| q | Renew |
| q | 20 Nm + 90° further |
| 14 - | Bolt |
| q | Tightening torque → Rep. gr.87 |
| 15 - | Bracket |
| q | For air conditioner compressor |
| q | Removing and installing → Chapter |
| 16 - | Tensioner |
| q | For poly V-belt |
| q | Lock in position with locking pin -T10060 A-. |
| 17 - | Air conditioner compressor |
| q | Removing and installing → Rep. gr.87 |
| 18 - | Bolt |
| q | Tightening torque → Rep. gr.87 |
| 19 - | Dowel sleeve |
| 20 - | Oil seal |
| q | For crankshaft (pulley end) |
| q | Renewing → Chapter |
