A1
Intake manifold - exploded view |
1 - | Guide tube |
q | For oil dipstick |
2 - | Seal |
q | Renew |
3 - | Gaskets |
q | Renew |
4 - | Bolt |
q | Tighten in diagonal sequence, working from centre outwards |
q | 8 Nm |
5 - | Fuel return line |
6 - | Bolt |
q | 9 Nm |
7 - | Bolt |
q | 9 Nm |
8 - | Intake manifold |
q | With intake manifold flap motor -V157- and intake manifold flap potentiometer -G336- |
q | Do not dismantle |
q | Removing and installing → Chapter |
9 - | Bracket |
q | For exhaust gas recirculation cooler change-over valve -N345- |
10 - | Bolt |
q | 9 Nm |
11 - | Exhaust gas recirculation cooler change-over valve -N345- |
12 - | Gasket |
q | Renew |
13 - | Bolt |
q | Tightening torque → Rep. gr.26 |
14 - | Pipe for exhaust gas recirculation |
q | To exhaust gas recirculation cooler |
15 - | Screw-type clip |
q | Tightening torque → Rep. gr.26 |
16 - | Connection |
q | For exhaust gas recirculation |
17 - | Bolt |
q | 8 Nm |
18 - | Seal |
q | Renew |
19 - | Throttle valve module -J338- |
q | With throttle valve potentiometer -G69- |
q | Removing and installing → Chapter |
20 - | Bolt |
q | 8 Nm |
21 - | Bolt |
q | Tightening torque → Rep. gr.17 |
22 - | Clip |