audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Identification of track rod ball joints > < Removing and installing track rod

A1

Checking and adjusting length of track rod (left-side)
Checking and adjusting length of track rod (left-side)
Special tools and workshop equipment required
   
t  Hose clip pliers -V.A.G 1275-
  W00-0451
–  Check dimension „a“ on left track rod and adjust as required.
Dimension -a- = 365 ± 5 mm
On a new track rod, check dimension „a“ before installing and adjust as required.
Then check total toe setting on wheel alignment unit and adjust as required; → Chapter, checking wheel alignment.
Installing boot
–  Check boot for wear (slits, tears) and check sealing surfaces for dirt.
  V48-1031
–  Install boot. First turn track rod so that joint pin of track rod ball joint is in installation position.
–  Tighten hose clip with hose clip pliers -V.A.G 1275-.
Only use genuine clips (same as original equipment).
The boot must not be twisted during installation.
  S48-0059

Identification of track rod ball joints > < Removing and installing track rod