Removing and installing data bus diagnostic interfaceJ533
Removing and installing data bus diagnostic interfaceJ533
Removing and installing data bus diagnostic interface -J533-
Special tools and workshop equipment required
t
Protective cap for cable connector -VAS 6223/9- from fibre-optic conductor repair set -VAS 6223-
Removing
–
When renewing control unit select „Replacement“ function for appropriate control unit in „Guided Fault Finding“ or „Guided Functions“ → Vehicle diagnostic tester.
–
Remove dash panel trim (driver's side) → Rep. gr.68.
–
Release retaining clip -1-, swivel data bus diagnostic interface -J--item 2- out of retaining frame -arrow- and take out.
–
Unplug electrical connector -3-.
–
If fitted, unplug electrical connector -4- for fibre optic cable.
–
Seal open connector plug -2- of fibre optic cable with protective cap for cable connector -VAS 6223/9--item 1-.
Note
Protective cap prevents contamination of or mechanical damage to end face of fibre optic cable which would impair light transmission.