Audi Workshop Service and Repair Manuals > A1 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Tail lights in body | Removing and installing rear lid closed sender 1G525

Removing and installing rear lid closed sender 1G525

Removing and installing rear lid closed sender 1 -G525-

Removing

–	Remove rear cross panel trim → Rep. gr.70.

–	Press retaining tab -2- to one side -arrow A- and pull connector -1- out of bracket -3-.

–	Move clear electrical wiring harness at brackets -5, 6-.

–	Release retaining tabs -arrow B- and detach rear lid closed sender -4-.

Installing

Installation is carried out in the reverse order; note the following:

–	Install rear cross panel trim → Rep. gr.70.

Audi Workshop Service and Repair Manuals