A2
| Poly V-belt drive - exploded view |
| 1 - | Poly V-belt |
| q | Check for wear |
| q | Do not kink |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | Removing and installing → Chapter |
| q | When installing, make sure it is properly seated on pulleys. |
| 2 - | Vibration damper |
| q | With pulley for poly V-belt |
| q | Removing and installing → Chapter |
| 3 - | Bolt |
| q | Renew; use only genuine bolts → Parts catalogue |
| q | 10 Nm +90° (1/4 turn further) |
| 4 - | Tensioner for poly V-belt |
| q | Pivot with open-end spanner to slacken poly V-belt |
| q | Lock tensioner with locking pin -T10060 A- |
| 5 - | Bolt |
| q | 23 Nm |
| 6 - | Bracket for ancillaries |
| q | Removing and installing → Chapter |
| 7 - | Bush |
| 8 - | Bolt |
| q | 23 Nm |
| 9 - | Alternator |
| q | Removing and installing → Rep. Gr.27 |
| 10 - | Bolt |
| q | 45 Nm |
| q | Install using locking fluid; for locking fluid refer to → Parts catalogue |
| q | Observe correct tightening sequence → Chapter |
| 11 - | Bush |
| q | 2 x |
| 12 - | Air conditioner compressor |
| q | Removing and installing → Rep. Gr.87 |
| 13 - | Bolt |
| q | 25 Nm |
