audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing vibration damper > < Poly V-belt drive - exploded view

A2

Removing and installing poly V-belt
Removing and installing poly V-belt
Special tools and workshop equipment required
   
t  Locking pin -T10060 A-
  W00-10235
Removing
–  Remove noise insulation -arrows-.
  Note
  A10-0684
Mark rotation direction of poly V-belt with chalk or a felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage.
–  Turn the tensioner in the direction of the -arrow- using a spanner to slacken the poly V-belt.
–  Lock tensioner in position by inserting locking pin -T10060 A- in locating holes.
–  Remove poly V-belt.
  A13-10121
Installing
Installation is carried out in the reverse order; note the following:
Vehicles not equipped with air conditioning:
–  Fit poly V-belt onto crankshaft pulley and alternator pulley.
  N13-0755
Vehicles with air conditioning:
–  Fit poly V-belt onto crankshaft pulley, alternator pulley and then onto A/C compressor pulley.
All models:
–  Release tensioner and remove locking pin from locating holes.
–  Make sure poly V-belt is properly positioned and correctly routed.
–  Start engine and check that belt runs properly.
  N13-0754

Removing and installing vibration damper > < Poly V-belt drive - exploded view