audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing front seat heating switches > < Removing and installing switches and instruments illumination regulator E20 / headlight range control regulator E102

A2

Removing and installing hazard warning switchE3
Removing and installing hazard warning switch -E3-
   
Removing
–  Switch off ignition and remove ignition key.
–  Remove the radio set/navigation control unit → Rep. Gr.91.
–  Remove screws -arrows- at centre air vents.
–  Reach through radio opening and carefully press frame -1- of centre air vents out of dash panel.
–  Detach electrical connector from hazard warning switch -E3-.
  A96-0729
–  Remove bolt -1-.
–  Release retaining clips -2- and -3- and remove hazard warning switch -E3--Item 4- with retaining frame -5- from air vents.
  A96-0730
–  Squeeze the retaining springs -arrow- and slide the hazard warning light switch -E3--Item 2- out of the mounting frame -1-.
Installing
–  Plug in the connector.
–  Install the radio or navigation system → Rep. Gr.91.
Tightening torques
  A96-0731
ComponentNm
Hazard warning switch -E3- to centre air vents1
Centre air vents to dash panelSmall radio slot1.8
Large radio slot3

   

Removing and installing front seat heating switches > < Removing and installing switches and instruments illumination regulator E20 / headlight range control regulator E102