A3 L4-2.0L Turbo (BPY) (2006)
-
Remove 2/3 right backrest. Refer to => [ Left 1/3 or Right 2/3 Backrest ] See: Service and Repair/Removal and Replacement/Rear Seats.
-
Remove the headrests. Refer to => [ Outer Headrests ] See: Service and Repair/Removal and Replacement/Rear Seats.
-
Remove center headrest. Refer to => [ Center Headrest ] See: Service and Repair/Removal and Replacement/Rear Seats.
-
Lift latch trim - 5 - off.
-
Remove seatbelt guide - 2 - upward.
-
Thread belt webbing - 3 - through opening - 1 - out of seatbelt guide - 2 -.
-
Remove peripheral retaining strips - 7 -.
-
Pry cover over outer bearing - 6 - (Qty. 2).
-
Raise cover and upholstery - 8 -.
-
Press headrest guides - 9 - and - 10 - upward and out.
-
Thread belt webbing - 3 - through upholstery.
-
Remove cover and upholstery - 8 -.
Installing
Installation is reverse of removal, but note the following:
-
Install headrest guide with button at left.
-
After installing latch trim - 5 -, ensure red lever - 4 - moves easily.
9
Right Headrest Guide
‹› Qty. 2
10
Left Headrest Guide With Button
‹› Qty. 2