A3 L4-2.0L Turbo (BPY) (2006)
‹› Rotate camshafts back and forth slightly if necessary to insert Camshaft Clamp (T10252).
‹› Ignore - arrows -.
-
If the Camshaft Clamp (T10252) cannot be inserted, remove guide frame again and repeat camshaft installation.
-
Remove Camshaft Clamp (T10252).
-
Drive in the sealing cap with the thrust piece (3334) approximately 1 to 2 mm deep.
-
Install camshaft sealing ring => [ Exhaust Camshaft Seal ] See: Seals and Gaskets/Camshaft Oil Seal/Service and Repair.
-
Install the rear toothed belt guard.
-
Insert fitting key into camshaft.
-
Install camshaft gear. To tighten bolt, hold camshaft gear in place using retainer (3036).
‹› When turning camshaft, pistons may not be at TDC for any cylinder. Valves/pistons may be damaged.
‹› Be sure fitting keys are properly seated.
-
Install toothed belt => [ Toothed Belt, without Divided Toothed Belt Guard ] See: Timing Components/Timing Belt/Service and Repair/Toothed
Belt, Without Divided Toothed Belt Guard or => [ Toothed Belt, with Divided Toothed Belt Guard ] See: Timing Components/Timing
Belt/Service and Repair/Toothed Belt, with Divided Toothed Belt Guard.
-
Install camshaft adjuster => [ Camshaft Adjuster ] See: Variable Valve Timing Actuator/Service and Repair/Camshaft Adjuster.
-
Install cylinder head cover => [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair.
The rest of the assembly is basically a reverse of the disassembling sequence.