A3 L4-2.0L Turbo (BPY) (2006)
/Page-4384002.png)
-
Remove screws -4- and remove steering column adjuster handle -3-.
-
Remove lower steering column trim.
-
Remove screws -1-, -2- and -5-.
-
Remove screw -1-.
CAUTION: DO NOT attempt to remove control module without releasing center retaining clip as described in next step. Damage to
control module will result.
-
Insert drill bit with Dia 2.5 mm (or equivalent tool such as a screwdriver etc.) as illustrated -2- approximately 45 mm into hole -arrow 1- in order
to release center retaining clip -arrow 2-. It may be necessary to twist the drill/tool slightly in order to release clip.
Only after center retaining clip has been released:
-
Pull module down slightly and remove drill/tool.
