A3 L4-2.0L Turbo (BPY) (2006)
Prevent contact with electrical components - arrow -.
‹› No seal remnants must enter sensor or housing when doing so.
-
Carefully lift seal from steering gear housing.
-
Observe general repair notes.
-
Disconnect connector from wiring harness and set aside.
It is needed to code new sensor wiring. Connector housing is not installed on new sensor wiring.
‹› A locking mechanism - arrow - for steering pinion spiral spring is located on sensor wire in steering gear housing. When removing the sensor
wire, make sure the spiral spring does not twist.