audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Installing key-operated switch > < Removing glove box

A3 Mk1

Converting glove box
Converting glove box
–  Make a sketch or take a photograph as a guide for routing the wiring harness on the glove box.
–  Remove glove box wiring harness.
–  If there are no cut-outs, the glove box will have to be converted.
   
–  Drill a hole with a diameter of 10 mm at edge of mark -1-.
–  Use commercially available compass saw to cut along mark -1- to a depth of approx. 80 mm, dimension -A-.
–  Drill a hole with a diameter of 3 mm, dimension -B- 39 mm and dimension -C- 16 mm.
  A70-0738
–  Mark projection line -2- with dimension -E- 15 mm.
–  Drill a hole with a diameter of 3 mm at dimension -D- 45 mm.
–  Cut a hole 38 mm (dimension -A-) from edge -1- at glove box, with dimensions -B- 11 mm and -C- 11 mm.
–  Install new glove box wiring harness.
–  Route and secure wiring harness on glove box according to sketch or photograph.
  A70-0737

Installing key-operated switch > < Removing glove box