Audi Workshop Service and Repair Manuals

• Spoiler
• ◆ In scope of delivery:
• ‒ Weather strip => Item 5
• ‒ Adhesive strip => Item 6
• ‒ Sponge rubber sealing strip => Item 7

• ◆ Removing
• ‒ Detach upper trim -8-.

=> General Body Assembly, Interior; Repair group 70; Trim panels; Removing and installing tailgate trim

• ‒ Remove Torx bolts -3- (4x).
• ‒ Detach spoiler from tailgate -2-.

• ◆ Installing

Notes:

• ◆ Clean bonding surface on tailgate with petrol, treat with silicone remover and rub dry.
• ◆ Only remove protective foil of adhesive strip after positioning on tailgate.
• ‒ Clean the bonding surface on tailgate -2- from adhesive residues, dust and grease.
• ‒ Check that the sealing washers -5-- are fitted on the underside of the spoiler fastening pin.
• ‒ Position spoiler on tailgate -2- and align.
• ‒ Remove protective foil of adhesive strip -6-. Use the aids provided on the protective film when pulling off.
• ‒ Press spoiler down firmly.

• ‒ Insert Torx bolts -3- (4x) with washers -4- (4x) and tighten.
• ‒ Install upper trim -8-.

=> General Body Assembly, Interior; Repair group 70; Trim panels; Removing and installing tailgate trim

• Tailgate
• Torx bolts (4x)
• ◆ 8 Nm
• Washers (4x)
• Sealing washer
• ◆ Bonded into spoiler -1-
• Adhesive strip
• ◆ Bonded into spoiler -1-
• Sponge rubber sealing strip
• ◆ Bonded into spoiler -1-
• Upper trim