audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Rear door,sliding door,wing doors,central locking > < Removing and installing actuator for fuel tank flap

A3 Mk1

General Body Assembly Exterior (Repair groups 50, 55, 57, 58, 60, 63, 64, 66)
Central locking, 5-door vehicles
Removing and installing pump for central locking system
 
A57-0073
  • ‒ Remove storage compartment in left side trim.
  • ‒ → Release cable ties -2-, open noise insulation -1-, disconnect electrical and pneumatic connectors, and remove pump for central locking system.
Important
Once all three connectors have been detached from the central locking system pump make sure that the centre 6-pin connector for the power supply is always re-attached as the last of the three connectors.
  • ‒ When installing the central locking pump, ensure that the pneumatic connectors engage properly.

Rear door,sliding door,wing doors,central locking > < Removing and installing actuator for fuel tank flap