Audi Workshop Service and Repair Manuals

Driver's seat

• ‒ Remove seat
• ‒ Remove fitting panel (tunnel side) => Page 72-147
• ‒ → Unscrew bolt -1- and detach transfer lever.

• ‒ → Detach Bowden cable -1- downwards from guide -2-.
• ‒ Remove tab -3-.

Passenger's seat

• ‒ Remove seat => Page 72-116
• ‒ Remove fitting panel (tunnel side) => Page 72-147
• ‒ Remove fitting panel on door side => Page 72-147
• ‒ → Unscrew bolt -1- and detach transfer lever.

• ‒ → Remove mounting plate -1- on opposite side and pull out transfer shaft -2-.

• ‒ → Detach Bowden cable -1- downwards from guide -2-.
• ‒ Remove tab -3-.
• ‒ Pull Bowden cable -1- through downwards.

All models, continued

• ‒ Remove memory module => Page 72-169
• ‒ → Lever out bearing -4- with a flat screwdriver.
• ‒ Lever out ball bearing -6-.
• ‒ Route Bowden cable -5- around spring lever -2-.
• ‒ Remove tab -1-.

•     3 -    Memory module