|
Removing
-
‒ Remove brake pads .
-
‒ → Insert brake pedal depressor V.A.G 1869/2 between brake pedal and driver's seat. Depress brake pedal at least 60 mm.
Note:
This closes valves in brake master cylinder and stops brake fluid reservoir running empty.
-
‒ Connect hose of bleeder bottle to bleed screw of rear brake caliper removed and front brake caliper on same side of vehicle.
-
‒ Open bleed screws.
-
‒ Close front bleed screw.
-
‒ Leave brake pedal depressor V.A.G 1869/2 in position.
-
‒ Unscrew brake hose from brake caliper.
Installing
Install in reverse order, paying attention to the following:
-
‒ Fit brake pads => Page 46-34.
-
‒ After fitting serviced or new brake caliper, adjust handbrake => Page 46-63. Do not press foot brake until handbrake has been adjusted.
-
‒ Bleed brake system: ABS/ESP Mark 20 .
Tightening torque
|
|
|---|
|
Component
|
|
Nm
|
|
Brake hose to brake caliper
|
38 1)
|
1) Replace brake hose/brake pipe with banjo bolt whenever banjo bolt has been slackened off
| 
