audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Specifications for pressures in refrigerant circuit > < Continuation of testing depending on design of refrigerant circuit
Checking pressures on vehicles with a restrictor and reservoir (with internally regulated air conditioner compressor)
Checking pressures on vehicles with a restrictor and reservoir (with internally regulated air conditioner compressor)
  Note
t  Connect air conditioner service station → Chapter.
t  Observe test requirements → Chapter.
–  Check the pressures in the refrigerant circuit (with the air conditioner service station) with the ignition switched off → Chapter.
The pressures with the ignition switched off correspond to the specifications.
–  Start engine.
–  Set engine speed to 2000 rpm.
–  Observe the pressure reading (e.g. pressure gauge) of the air conditioner service station.
  Note
t  Switching pressures for refrigerant circuit switches are vehicle-specific.
t  The connection with valve for the low-pressure switch or at the evaporator is only to be used for vehicles with no service connection on the low-pressure end and an inaccessible connection at the air conditioner compressor or reservoir (measurement accuracy). Only applies to certain vehicles → Heating, air conditioning; Rep. gr.87 or → Air conditioning; Rep. gr.87 (vehicle-specific workshop manual).
t  Specifications for pressures in refrigerant circuit → Chapter
   

Specifications for pressures in refrigerant circuit > < Continuation of testing depending on design of refrigerant circuit