A3 Mk1
| Dismantling and assembling gearbox housing and selector mechanism |
| 1 - | Countersunk bolt |
| q | 25 Nm |
| 2 - | Flange shaft with spring |
| q | Removing and installing → Chapter |
| q | Assembling → Chapter |
| 3 - | Bolt |
| q | Tightening sequence and torque → Anchor |
| q | For reverse shaft support |
| q | Self-locking |
| q | Always renew |
| 4 - | O-ring |
| q | Always renew |
| 5 - | Pivot pin |
| 6 - | Bolt |
| q | 25 Nm |
| 7 - | Bolt |
| q | 25 Nm |
| 8 - | Cover plate |
| 9 - | Gearbox housing |
| q | Servicing → Chapter |
| 10 - | Clutch housing |
| q | Servicing → Chapter |
| 11 - | Bolt |
| q | 25 Nm and turn 90° further |
| q | Always renew |
| 12 - | Selector mechanism |
| q | Dismantling and assembling up to 09.98 → Chapter |
| q | From 09.98, a modified selector mechanism has been used |
| q | Dismantling and assembling from 09.98 → Chapter |
| 13 - | Bolt |
| q | 25 Nm |
