A3 Mk1
| Installation position of selector mechanism up to 09.98 |
| -Arrow A- gear selection movement |
| -Arrow B- gate selection movement |
| A - | Gear selector cable (gear selection movement) |
| B - | Gate selector cable (gate selection movement) |
| C - | Heat shield |
| q | Detach before removing selector mechanism. |
| 1 - | Gearbox selector lever |
| 2 - | Relay lever with actuating arm/gate selector cable |
Note| t | Note radio coding for vehicles with coded radio. |
| t | Before working on selector mechanism in engine compartment, disconnect earth strap from battery → Rep. Gr.27. |
| t | Follow the steps required when re-connecting the battery → Rep. Gr.27. |
| t | Do not kink selector cables. |
| t | Apply polycarbamide grease -G 052 142 A2- to all bearings and contact surfaces. |
| I - | Removing and installing selector cables - exploded view → Chapter |
| II - | Servicing selector housing → Chapter |
| Removing and installing selector mechanism → Chapter |
| III - | Servicing gear lever → Chapter |
| → Chapter „Adjusting selector mechanism up to 09.98“ |
