audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Selector cables to 06.2001 - exploded view of components > < Gear lever knob and boot - exploded view of components

A3 Mk1

Gear lever and selector housing - exploded view of components
   
Gear lever and selector housing - exploded view of components
  Note
Lubricate all bearings and moving surfaces with polycarbamide grease -G 000 450 02-.
1 - Circlip
q   Removing and installing → Fig.
2 - Bush
3 - Spring
4 - Bush
5 - Torx bolt, 5 Nm
6 - Cover
7 - Damper
8 - Bearing shell
9 - Gear lever guide
10 - Damping washer
11 - Gasket
q   Between selector housing and floor
q   Self-adhesive
q   Bond to selector housing
12 - Bolt, 25 Nm
13 - Bracket
q   Secured on body
14 - Hexagon nut, 25 Nm
q   For bracket on body
15 - Gear lever
16 - Damper
17 - Selector housing
18 - Mounting bush
19 - Pivot pin
20 - Guide bush
21 - Spring
q   Installing → Fig.
22 - Gate selector bracket
23 - Torx bolt, 5 Nm
24 - Floor plate
q   Bend tabs open to remove
q   Renew
25 - Gate selector cable
q   On gate selector bracket
q   Installation position → Chapter
26 - Gear selector cable
q   Press onto gear lever guide
q   Installation position → Chapter
27 - Securing clip
28 - Hexagon nut, 25 Nm
29 - Mounting bush
q   Only fits in one position.
30 - Circlip

   
Removing and installing circlip
–  To remove and install circlip -arrow A-, use screwdriver to press spacer bush -arrow B-in direction of -arrow C- as far as stop and detach circlip.
  Note
t  Keep spacer bush straight while pushing down.
t  Groove in gear lever for circlip must be visible.
t  Release spring carefully.
  N34-1363
Installing spring
–  Insert spring so that the spring extension -A- is under the pin -arrow-.
–  Then pull spring extension -B- up towards gear lever until it lies on upper section of pin -arrow-.
  N34-0892

Selector cables to 06.2001 - exploded view of components > < Gear lever knob and boot - exploded view of components