A3 Mk1
| Selector cables from 07.2001 - exploded view of components |
Note| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Gear selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| 2 - | Gate selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| 3 - | Securing clip |
| q | Renew |
| 4 - | Circlip |
| q | Take care not to damage selector cables when removing. |
| q | Renew |
| 5 - | Selector housing |
| 6 - | Hexagon bolt, 20 Nm |
| q | 2 x |
| 7 - | Support bracket |
| 8 - | Grommet |
| q | For support bracket mounting on gearbox |
| 9 - | Distance piece |
| 10 - | Nut, 20 Nm |
| 11 - | Cable end-piece |
| q | Secures gate selector cable to relay lever |
| q | Do not interchange with → Item; different version → Fig. |
| 12 - | Relay lever |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| 13 - | Mounting bush |
| 14 - | Securing clip |
| q | Renew after removing |
| 15 - | Slide block |
| 16 - | Selector shaft lever with damper weight |
| q | Install so that gap in splines aligns with selector shaft |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| 17 - | Hexagon nut, 23 Nm |
| q | Self-locking |
| q | Renew |
| 18 - | Cable end-piece |
| q | Secures gear selector cable to selector shaft lever |
| q | Do not interchange with → Item; different version → Fig. |
|
|
