A3 Mk1
Note
|
| 1 - | Circlip |
| q | Different thicknesses |
| q | Do not interchange with circlips of other clutches |
| q | Mark after removal and re-install at same location |
| 2 - | Pressure plate |
| q | Installation position: smooth side faces inner plate |
| 3 - | Inner plate |
| q | Quantity → Chapter |
| q | Soak new inner plate in ATF for 15 minutes before installing. |
| 4 - | Outer plate |
| q | Quantity → Chapter |
| 5 - | Corrugated washer |
| 6 - | Circlip |
| q | Removing and installing → Fig. |
| q | Do not interchange with circlips of other clutches |
| q | Mark after removal and re-install at same location |
| q | Installation position → Fig. |
| 7 - | Spring support plate |
| q | With springs |
| q | Installation position → Fig. |
| q | To fit, preassemble with spring support ring Ensure springs are correctly seated |
| 8 - | Spring support ring |
| 9 - | Piston |
| q | Sealing lips are vulcanised to piston |
| q | To remove, prise out of clutch housing by applying screwdriver at several points |
| q | Moisten sealing lips with ATF before installing |
| q | Keep piston straight when installing |
| 10 - | Clutch housing |
| q | With ball valve -arrow- |
