A3 Mk1
| Items supplied with exchange component |
| 1 - | ATF pump with piston “B2” |
| 2 - | Components of brake “B2” |
| q | → Anchor |
| 3 - | Reverse gear clutch “K2” |
| 4 - | Shims for clutch clearance |
| q | Shims are colour-coded to indicate different thicknesses |
| 5 - | 1st to 3rd gear clutch “K1” |
| q | Clutches “K1” and “K3” may be pressed together |
| 6 - | 3rd and 4th gear clutch “K3” with turbine shaft |
| q | Clutches “K1” and “K3” may be pressed together |
| 7 - | Axial needle bearing with washer |
| 8 - | Freewheel with piston “B1” |
| 9 - | Components of brake “B1” |
| q | → Anchor |
| 10 - | ATF strainer |
| 11 - | Valve body |
| Components of brake “B1” |
| 1 - | Circlip |
| q | For supporting tube “B2” |
| 2 - | Circlip |
| q | For freewheel |
| 3 - | Freewheel |
| q | With piston “B1” |
| 4 - | Dished spring |
| 5 - | Pressure plate “B1” |
| 6 - | Inner plate “B1” |
| 7 - | Outer plate “B1” |
| 8 - | Shim |
| Components of brake “B2” |
Note| Brake “B2” is supplied in two versions. |
| A - | Brake “B2” |
| q | Version with corrugated washer |
| q | Code letters → Chapter |
| 1 - | Corrugated washer |
| 2 - | Outer plate “B2” |
| B - | Brake “B2” |
| q | Version with retaining ring |
| q | Code letters → Chapter |
| 3 - | Retaining ring |
| 4 - | Shim |
| Clutches |
Note| Clutches “K1” and “K3” exist in two versions. |
| A - | Clutches -items 3, 4, 5- are pressed together |
| B - | Clutches can be loosely fitted together |
| 1 - | Reverse gear clutch “K2” |
| 2 - | Shims for clutch clearance |
| q | Up to 3 shims may be fitted |
| 3 - | 1st to 3rd gear clutch “K1” |
| 4 - | O-ring |
| 5 - | 3rd and 4th gear clutch “K3” with turbine shaft |
| 6 - | Axial needle bearing with washer |
| Valve body with ATF strainer |
| 1 - | Steel spring and bolt |
| q | For operating rod for manual selector valve |
| 2 - | Sealing plug for freewheel |
| q | Must be ordered separately if required |
| 3 - | Valve body |
| q | Supplied without conductor strip |
| q | Conductor strip must be ordered separately if required |
| 4 - | Seal |
| q | Press onto suction collar on ATF strainer |
| 5 - | ATF strainer |
| 6 - | O-ring |
| 7 - | O-ring |
