audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Reading measured value block > < Erasing fault memory

A3 Mk1

Automatic gearbox 01M Self-diagnosis
Initiating basic setting
Initiating basic setting

Note:

The basic setting should be initiated after performing the following repairs:

  • ◆ Exchanging engine
  • ◆ Replacing engine control unit
  • ◆ Replacing throttle valve control part -J338
  • ◆ Replacing the automatic gearbox control unit -J217
  • ◆ Replacing clutches and valve body

Requirements:

  • ● Voltage supply OK and all electrical components switched off.
  • ● Setting of throttle cable OK.
  • ● Fault memory interrogated, any faults rectified and fault memory erased.
  • ‒ Connect fault reader V.A.G 1551, enter address word "02 Gearbox electronics" and advance the programme until the display shows "Select function XX" => from Page 01-25.
Warning!
Secure fault reader to rear seat and operate from this position. Observe safety precautions Page 01-26
 
→ Indicated on display:
Rapid data transfer     HELP
Select function XX
  • ‒ Press keys 0 and 4. (The function "Initiating basic setting" is selected with 04).

Note:

Accelerator pedal must remain in idling position.
 
→ Indicated on display:
Rapid data transfer     Q
04 Basic setting
  • ‒ Confirm entry with key Q.
 
→ Indicated on display:
Basic setting    HELP
Enter display group number XXX
  • ‒ Press key 0 three times.
  • ‒ Confirm entry with key Q.
 
→ Indicated on display:
System in basic setting    0    ⇒

The system is now in the basic setting.

  • ‒ Depress accelerator pedal as far as kickdown and hold in this position for 3 seconds.
  • ‒ Press key ⇒.
 
→ Indicated on display:
Rapid data transfer     HELP
Select function XX

Reading measured value block > < Erasing fault memory