A3 Mk1
| Dismantling and assembling selector mechanism |
| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Selector lever handle |
| q | Removing and installing → Chapter |
| 2 - | Sleeve |
| q | Clips into selector lever handle |
| q | Prevents selector lever handle from being pulled off |
| 3 - | Cover |
| q | Includes symbol panel |
| q | Clipped into frame -item 5- |
| 4 - | Printed circuit |
| q | Can be tested via electrical check and measured value block → Automatic gearbox 09A, self-diagnosis; Rep. gr.01 |
| 5 - | Frame |
| q | With sliding cover |
| 6 - | Cable clip |
| q | Inserted in frame -item 5- |
| 7 - | Bracket |
| q | For selector lever cable |
| q | Fitted on heat shield for tunnel (front) |
| 8 - | Locking plate |
| q | Secures selector lever cable to shift unit |
| q | Always renew |
| 9 - | Selector lever cable |
| q | Do not bend or kink |
| q | If the protective sleeve is damaged, the selector lever cable must be renewed |
| q | Checking and adjusting → Chapter |
| q | Removing and installing → Chapter |
| q | Do not lubricate cable eye and ball socket |
| 10 - | Flange nut |
| q | 10 Nm |
| q | For securing cover to shift unit |
| q | 4x |
| q | Self-locking |
| q | Always renew |
| 11 - | Cover |
| q | For shift unit |
| q | With glued-on gasket |
| 12 - | Bolt |
| 13 - | Pawl |
| q | For selector lever lock |
| q | Engages in cable lever of shift unit |
| 14 - | Selector lever lock solenoid -N110- |
| q | Can be renewed with selector mechanism installed in vehicle |
| q | Removing and installing → Chapter |
| q | Can be tested via electrical check and measured value block → Automatic gearbox 09A, self-diagnosis; Rep. gr.01 |
| 15 - | Shift unit |
| q | Removing and installing → Chapter |
| 16 - | Locking cable |
| q | For ignition key removal lock |
| q | Must not be kinked |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| q | Checking ignition key removal lock → Chapter |
| 17 - | Steering lock |
| 18 - | Clip |
| q | Installation position: Fit clip from above. Angled ends of clip must point towards steering lock. |
